Dogtra YS600 Stubborn Dog No Bark Collar
This Dogtra YS600 Stubborn Dog No Bark Collar is fully waterproof with 7 different intensity settings. This system is designed for medium and large breeds.
Q: How long does it take to fully recharge the batteries, and how long do the batteries last after a charge?
A: The Dogtra YS600 has rapid charge batteries. It takes around 2 hours to recharge the batteries if they are completely deprived. The LED indicator light stays red while being charged. The light will change to a green color and stay on without blinking when the battery is completely charged. It may vary from the frequency of uses, but the batteries should last for about 2 weeks.
Q: What do the letters and numbers on the dial mean?
A: The letter “P” on the Dogtra YS600 dial is the Vibration setting, a non-stimulation mode. The numbers 1-10 are stimulation settings, the higher the number the higher the stimulation. The “T” is the Test Mode of the collar.
Q: Is the Dogtra YS600 waterproof?
A: Yes the collar is waterproof, if the dog is out in the rain, the collar will not be affected.
Q: What size dog does the Dogtra YS600 Bark Collar fit?
A: The Dogtra YS600 Bark Collar is for dogs of at least 30 pounds and recommend to be on a dog of 6 months of age or older.
Q: Fitting the Dogtra YS600 to the dog properly
A:The collar should be snug against the dog’s skin, but not so tight that the dog cannot eat or drink without ease. The collar should not be able to slide around the dog’s neck. The prongs on the collar should be directly on the skin, to ensure that the dog will feel the correction. To get the prongs in contact the skin, wiggle it back and forth to get it through the dog’s coat.
Q: The dog is not responding to the correction
A: If the dog is not responding to the Dogtra YS300 stimulation, make sure that the prongs are against the dog’s skin. If it is, turn the dial up on the stimulation, every dog responds different to the shock and a higher setting may be needed.
Q:Testing the Dogtra YS600
A: To test the collar, turn the collar into Test mode, “T”, the collar will blink every 4 seconds. Scratch in between the 2 contact points with something like a cap of a pen, if it vibrates twice then it is working.